Selecting the working mode

The power tool has 2 preset working modes.

User Interface

Description

Instructions

Turbo mode working mode

In Turbo mode, the power tool is run up to maximum performance.

Note: This working mode only works if the power tool is set to clockwise.

  1. Make sure that the power tool is set to clockwise.
  1. Press the MODE button (7) until the Turbo mode indicator (5) lights up.

ABR (Auto Bolt Release) working mode

The ABR working mode is used for releasing bolts or nuts: The power tool automatically shuts down when the bolt or nut is released. The automatic shutdown prevents:

  • The bolt from falling down when released from the material
  • The nut from falling down when released from the screw thread

Note: This working mode only works if the power tool is set to anticlockwise and the bolt or nut is still securely bolted. If bolts or nuts have already been released, the automatic shutdown (ABR) is not active.

  1. Make sure that the power tool is set to anticlockwise.
  1. Press the MODE button (7) until the automatic shutdown (ABR) indicator (6) lights up.