Checking Slopes

- Mount the measuring tool in the horizontal position on a tripod (26).
- Select rotational operation.
- Set up the tripod with the measuring tool so that the Y-axis is aligned with the slope that is to be checked.
- Position the target slope as the slope for the Y-axis see Slope operation in the horizontal position.
- Secure the laser receiver (24) to a measuring rod (25) with the holder .
- Place the measuring rod at the base of the inclined surface.
- Align the height of the laser receiver on the measuring rod so that the variable laser beam (1) of the measuring tool is indicated as centred.
- Then position the measuring rod with the laser receiver, one after the other, at different test locations on the slope surface.
- Make sure that the laser receiver remains in the same position on the measuring rod.
If the slope of the plane is correct, the laser beam will be indicated as "centred" at all test locations.