Manual operation

The automatic levelling of the measuring tool can be switched off (manual operation).

  1. Press the  button and the  button simultaneously for 2 s to switch off automatic levelling.
  1. <--> is continuously shown in red in the slope angle indicator (8).

It is possible to set up the measuring tool at any inclination in manual operation mode.

You can also tilt the Y-axis in a range of ±15 %.

  1. Press the  button to tilt the laser plane in a Y– direction.
  2. Press the  button to tilt the laser plane in a Y+ direction. 
No inclination values appear on the display during manual operation.
  1. To switch automatic levelling back on, press the  button and the  button simultaneously for 2 s.