Setting the torque (see figure H)

The torque depends on the spring preload of the shut-off clutch. The shut-off clutch is triggered upon reaching the set torque, both in clockwise and anticlockwise rotation.

Only use the supplied adjustment tool (20) to set the individual torque.

• Push the cover for the clutch back.
• Insert the application tool (20) into the small protrusion (setting disc (21)) of the clutch and turn the adjustment tool (20).

Turning clockwise will result in a higher torque; turning anticlockwise will result in a lower torque.

• Remove the adjustment tool (20). Push the cover for the clutch  until the opening is closed to protect the clutch from contamination.

Note: The required setting is dependent on the type of threaded connector and can be best determined by practical trials. Check a trial screw application with a torque spanner.