User interface

The user interface (9) is used to select the working mode and to indicate the status of the power tool.

Status indicators

Power tool status indicator (15)	Meaning/cause^A)	Solution
–	Power tool is switched off	–
Green	Power tool is switched on and ready to use	–
Yellow	Critical temperature of electronics reached. The power of the power tool is throttled in order to prevent damage.	Run the power tool at no load and allow it to cool down until the indicator (15) lights up green again
Yellow In combination with lit maintenance indicator (13)	Regular power tool maintenance due soon	Send the power tool to the after-sales service
Yellow In combination with flashing maintenance indicator (13)	Regular power tool maintenance due	Switch off the power tool immediately and send it to the after-sales service
Flashing blue	Power tool is connected to a mobile device or settings are being transferred.	–
Red	Power tool has overheated. The power tool is switched off in order to prevent damage to the electronics.	Leave the power tool to cool down. Only when the indicator (15) lights up green upon switching on is the power tool ready for use again.
	Restart protection is triggered. The power tool is prevented from starting up again following a power outage (e.g. if the mains plug is removed during operation) in order to prevent injuries.	Switch off the power tool and restore the power supply. Then switch the power tool on again.
	Lock-on button pressed in "hammer drilling" operating mode	Press the lock-on button again
	Rotation stop switch activated during operation	Switch the power tool off and on again
	General error	Switch the power tool off and on again Disconnect the power tool from the power supply and reconnect it If the error persists: Send the power tool to the after-sales service
Flashing red In combination with the lit rapid shut-off indicator (12)	Rapid shut-off is triggered.	Press the lock-on button and release the on/off switch

A): Read the notifications in the smartphone app.

Selecting the working mode

Press the (18) button for selecting the working mode repeatedly until the working mode you require lights up.

Note: The functions are preset in Auto and Soft work modes. In Favorite working mode, the preset functions can be configured via a smartphone app.

	Working mode
	Auto	Soft	Favorite
Indicator on the user interface	–	Indicator (11) lights up white	Indicator (10) lights up white
Performance	100 %	Reduced power (80 %) for processing sensitive materials	Individual configuration via smartphone app Default setting: 90 %
Soft start (Electronic Precision Control)	Fast, controlled run-up up to maximum power	Controlled run-up up to a reduced, low power	Individual configuration via smartphone app Default setting: Fast run-up
Sensitivity of the rapid shut-off (KickBack control)	Standard	Standard	Individual configuration via smartphone app Default setting: standard
High Altitude Mode (Atmospheric pressure compensation if the power tool does not start in Auto mode at great height)	Off	Off	Individual configuration via smartphone app Default setting: Off

Note: Press and hold the button (16) for longer than 6 seconds in order to reset the Favorite working mode to the factory settings (reset).