Technical Data
Angle Grinder | ||||||
|---|---|---|---|---|---|---|
Article number | ||||||
Rated power input | W | 2800 | 2800 | 2800 | 2800 | 2200 |
Rated speed | min–1 | 8500 | 6500 | 8500 | 6500 | 6500 |
Max. grinding disc diameter | mm | 180 | 230 | 180 | 230 | 230 |
Grinding spindle thread | M 14 | M 14 | M 14 | M 14 | M 14 | |
Max. thread length of grinding spindle | mm | 25 | 25 | 25 | 25 | 25 |
Kickback stop | ● | ● | ● | ● | ● | |
Restart protection | ● | ● | ● | ● | ● | |
Soft start | ● | ● | ● | ● | ● | |
Run-out brake | ● | ● | ● | ● | ● | |
Status indicator (LED) | ● | ● | ● | ● | ● | |
PROtection switch | – | – | ● | ● | – | |
Weight according to EPTA-Procedure 01:2014 | kg | 5.7 | 5.9 | 5.7 | 5.9 | 5.9 |
Protection class |
|
|
|
|
|
/ IIThe specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
The appliance meets IEC 61000-3-11 requirements and is subject to conditional connection. The appliance can lead to occasional voltage fluctuations under unfavorable power conditions. The impedance of this appliance is set as Zactual = Ω. The user must make sure, that the connection point, with the impedance Zmax, on which the appliance shall be plugged in meets the impedance requirement: Zactual ≥ Zmax. If Zmax is unknown, determine Zmax in consultation with the network supplier or supply authority.